6502 Opcode 8B (XAA, ANE)
(Created page with "Of all the unsupported opcodes, 8B has had a lot of attention because it seems unpredictable. Even the same computer has been seen to act differently even with the same inputs. ...")
Newer edit →
Revision as of 12:04, 10 January 2011
Of all the unsupported opcodes, 8B has had a lot of attention because it seems unpredictable. Even the same computer has been seen to act differently even with the same inputs.
The reason is that this opcode connects the A register to SB (the Special Bus) at both input and output: in a sense, A is both read and written. Unlike the stack pointer, the A register is not designed to do that, and the result is a circuit configuration which behaves in an interesting way.
Note that our switch-level simulation tends to produce wired-AND behaviour: if two logic gates both drive the same wire, then either of them can drive it low. A real 6502 usually does the same, which is why 8B - often called XAA - will more or less AND together the three inputs: the X register, the A register, and the immediate operand.
Why more or less? Two reasons: the A register is fed back on itself, and because of an interaction with the RDY input.
The A register drives the SB directly, and bits 0 and 4 read SB directly. The other 6 bits read SB through the Decimal Adjust logic, which doesn't affect the logic value but does affect the timing, the logic thresholds and the drive strengths. Exactly what happens is an analogue problem, not a digital one, so it will depend on the exact model of CPU, the variations of chip manufacture, the power supply and the temperature. We can't even model this without knowing the transistor strengths and having some idea of the transistor parameters - which we can only guess at.
The RDY input is a more digital influence on the outcome. RDY is intended to stall the CPU during read accesses, so it can read from slow memory. As it happens, the 6502 samples the databus on every falling clock edge, and loads the IDL (Input Data Latch), and then drives into the target register. Normally, the final cycle is the one which counts, overwriting the stray external values. In some computers, RDY is used to stall the CPU while the bus is used for DMA, which means the bus contains data such as video data for several cycles, except the last. In the case of XAA, every cycle's data is ANDed into A, and this is why the final value of A changes even for the same values of operand, X and A.